Hardware Compatibility

Hardware	Minimum EnsensoSDK Version
B-Series	4.0
C-Series	3.5
N20/N30/N35	1.3.180
N40/N45	2.3.1536 1
N31/N36/N41/N46	3.4.0
S10	3.2.0 3
X-Series, 1.3MP	2.0.97 5
X-Series, 1.6MP	3.1.480 2 3
X-Series, 5MP	2.2.27 3 4
XR-Series, 1.6MP	2.3.581 3
XR-Series, 5MP	3.1.480 3

Calibration Patterns

Pattern Type	Minimum EnsensoSDK Version
390mm Ensenso pattern with 96mm grid spacing	4.1.1033
Ensenso patterns on 4mm glass	3.6.1631
Ensenso	2.2.27
Halcon	All versions

1

There is limited support for N4x-series cameras in any version that supports the N3x cameras. These versions might show the wrong model name, but the device will otherwise run normally.

2

There is limited support for X-series cameras with 1.6MP sensors since version 2.3.581. Pairing a projector with 1.6MP sensors in these versions will show a warning that the sensor model is not supported. This can be ignored, the device will still run normally.

3(1,2,3,4,5)

For IDS GigE Vision sensors there are newer hardware revisions x.2. They require a new firmware version, which is only shipped with SDK ≥ 3.4.743. This affects devices built in 2023 and later. The support team can provide detailed revision information for a specific serial number. The devices are shipped with a working firmware version and will work with older SDK versions as listed above, but there might be warnings about unsupported firmware versions.

4

For the 5MP IDS GV-5280 sensors there is a new hardware revision x.2, which requires a new firmware version as described above. Devices are shipped with a working firmware version, but it is only compatible with SDK 2.3.1527 and later.

5

There is a new hardware revision x.2 for the 1.3MP IDS UI-5240 sensors. This affects devices built in 2023 and later. The support team can provide detailed revision information for a specific serial number. This revision requires at least uEye driver 4.96.1 and SDK 3.4.743.