Retrieve

Retrieves a previously triggered image from one or more cameras.

If a camera is in hardware trigger mode, the command can wait for the trigger signal with a user-defined (Timeout).

Note

Please also have a look at the Capture command which performs Trigger and Retrieve operations together.

Note

While the command is waiting for an image, it can be interrupted with the Break command (e.g. to stop waiting for a hardware trigger signal).

Error Symbols

• "CaptureTimeout": The camera did not transfer images within the specified timeout. Increase the timeout or investigate possible errors with the hardware trigger signal or the network image transfer.

• "ImageTransferFailed": The image could not be transferred over the USB bus. Decrease the PixelClock parameter or disconnect any other devices from the same USB bus. You might also want to try a different USB port on your computer and verify that the camera is connected as the only device to one of your system’s USB root hubs.